Configuration checklist¶
Before using any crtomo.cfg
file check the following settings:
- Robust/non-robust
- Anisotropic filtering?
- Homogeneous starting model (use F if you invert surface configurations, this will use an average of the data values as the starting model)
- Magnitude errors (abs. error of 1e-4 stabilzes)
- Phase errors
- FPI?
- Start FPI with homogenous starting model (only if phases get over fitted in complex inversion)?
- Error ellipsis enabled/disabled?
Todo
An explanation what the different settings are about and how to change them would be helpfull.
Warning
The following “standard” inversion scheme are really old and should be reviewed and modified to adapt modern inversion practices!
Standard inversion schemes¶
The following inversion schemes can be used for initial screenings of the data if no error analysis was made. They can also be used as a starting point for further error parameter adaption.
Todo
How to make an error analysis? Is there a section, then link it here. If there is no such section, then create one.
Each scheme denotes important parameters to be changed in the crtomo.cfg
file.
Normal¶
- 5 % Magnitude error + \(1e^{-4}\Omega\)
- 2 mrad phase error
- robust inversion
- no homogeneous starting model for FPI
Optimistic¶
- 5 % Magnitude error + \(1e^{-4}\Omega\)
- 1 mrad phase error
- non-robust inversion
- no homogeneous starting model for FPI
Pessimistic¶
- 10 % Magnitude error + \(1e^{-4}\Omega\)
- 4 mrad phase error
- robust inversion
- no homogeneous starting model for FPI